Hi,
The error you get is usually due to ISP connection problems or the absence of external quartz. The image is correct, if in reality it is the same, then there may be several problems: incorrect fuses, incorrect virtual board, incorrect IDE command, micro bricked, real loss of the signature.
Unfortunately, the question becomes complex and is not on a blog that can be solved. The only possibility is to write on the official Arduino Forum, where you can open a specific thread.
Best regards.

the connection made as show below , and off course HC-05 direct to arduino as shown above .
https://uploads.disquscdn.com/images/06718741358da362b79a04d160d164730d464f618aa9e254e627640f2e223290.jpg

If I do not see how you made the connections between the arduino programmer and the micro stand-alone I can not understand what is happening; there are many error factors: virtual board, IDE set badly, IDE command executed, connections, stand-alone with wrong mergers …

Hi Michele ,

i dont have for now , but i can describe it more easily .

i have arduino uno connected with HC-05 for uploading sketches , and this working fine .

i uploaded the arduino-isp sketch to arduino , but when try to use it as isp to program a atmega on a breadboard ,or to burn a boot loader i got the above error .

noting that : when connect the usb cable to arduino its working normally uploading sketches & working also as isp without any problems .

please check photos https://uploads.disquscdn.com/images/bd92fbaec5680a35b62d32dfb6a446ee89227d99a59b265c5658109fad24bf28.jpg https://uploads.disquscdn.com/images/7ef766567fde3c64244f64a74a97d58eb908bacb4312bb3d2a52b196ae4de14b.jpg .

Hi,
I need a photo your circuit on breadboard with all connections

i read all your comments here but unfortunately cannot find a solution for my problem and hope you can provide any support please .

i have HC-05 Bluetooth module connected to atmega328p loaded with uno bootloader on a breadboard .

i can upload any sketch to the atmega fine , i uploaded the arduino-isp sketch to the atmega with success ,

now the issue occurred , when connecting another atmega328p to this atmega for programing (miso,mosi,sck,reset), i received :
avrdude: Device signature = 0x000000
avrdude: Yikes! Invalid device signature.
Double check connections and try again, or use -F to override
this check.

i checked the connection , the connection is ok , also the same happened if i tried to burn the bootloader .

i tried many boards with many config , but the same .

noting that if i do the above with arduino uno board connected with usb with the same wiring and the same chip , everything is going fine .

so what is the problem here ?

welcome dear

Thank you, Marlin

http://arduinounotutorials.com/